Install the projector so that projected images are projected onto the screen at the optimum size by referring to the table below. Attaching the Terminal Cover Align the hook on the terminal cover with the insert hole in the hook at the back of the projector. A Fan Mode also offers a High setting for high-altitude operation. Service Information for the U. Do not remove the lamp Warning! Communication conditions Set the serial port settings of the computer as follows. The projector has two iris controls. This does not indicate malfunction.
The selectable items vary depending on the selected input, input signals, or adjustment values. C-Saturation —30 — +30 C. The lamp and parts around the lamp will be very hot and may cause burns or injury. Y-Saturation —30 — +30 C. This much offset might be fine for a ceiling mount, but it can cause problems in a tabletop setup. The image becomes brighter while the color reproduction is kept at a high level. The cooling fan runs for about 90 seconds.
For disposal or recycling information, please contact your local authorities or, if you are located in the United States of America, the Electronic Industries Alliance: www. Sharp remote control signal format Transmission format: 15-bit format 67. Indicates safeguards when using the projector. The illustration shown here is for explanation and may be different from the actual on-screen display. B-Saturation —30 — +30 C. Marks Used in This Operation Manual Info.
M-Saturation —30 — +30 C. Items that cannot be selected will be grayed out. Each of these modes offers four different adjustments: Hue, Saturation, Value, and Effect. If the projector is carried from a cold room into a warm room, or if it is suddenly heated, condensation Picture is blurred;. The color temperature adjustment has five steps —2 to +2 , plus it has separate red and blue controls to fine-tune the color calibration. See page 40 for details.
. But the latter are overall color adjustments only. If the temperature continues to rise, the lamp will turn off, the. This included proper handling of 3:2 pulldown inverse telecine in all cases. Switching the Iris Setting This function controls the quantity of the projected light and the contrast of the image. Value is the brightness of the adjusted color.
See page 24 for connection. Contact your nearest Sharp Authorized Service Center or Dealer. While the Input list is displayed, follow the procedure below to switch the Input mode. R-Saturation —30 — +30 C. Refer to the information that came with the system for instructions on how to use it to secure the projector. The projector is respectably quiet overall, particularly in Eco+Quiet. If any of the indicators illuminates, follow the relevant procedures given below.
It also has a five-position Gamma control, an Overscan control, and a Video Setup control for analog video inputs at 480i. Using the Terminal Cover When the projector is used on a desktop, high mounted or ceiling mounted, attach the terminal cover supplied to hide the connecting cables. For details, see the pages suggested in each step. Selecting the Progressive Mode For selecting the progressive display of a video signal. In case of lamp rupture, contact your nearest Sharp Authorized Service Center or Dealer for replacement.
Disposal of these materials may be regulated due to environmental considerations. There are no separate high and low controls and no green. It even has a carrying handle that slides out from one side. In its black, rectangular case, it weighs less than 13 pounds. Selectable items Description The Unveil Control function is not activated. This product has been engineered and manufactured to as- sure your personal safety. A protective shutter that you can slide in front of the lens takes the place of the usual lens cap.