Then press the engine start-up button 3-4 times, making the engine and the spark plug slowly turn. Press from inside the handlebar coverage, remove all the switches. Carefully lower the workshop jack and remove the fuel tank. Remove the rear suspension arm from the frame. Carry out the separation of the crankcase.
Attach the spring to the shoe and insert the latter on the upper pin. Specific tooling 020095Y Flywheel Lock Using the appropriate tool, unscrew the lock-nut of the flywheel. Clean and bleed the air out of the system. Connect the connection between the magnet fly- wheel and the voltage regulator. Specific tooling 021467Y Bearing extractor 021467Y013 extractor 021467Y009 extractor After warming the crankcase, remove it with light taps of the hammer. Remove, from the suspension arm, the brake line from the brake distributor.
Insert the bearing in its seat. Fit the bench ball bearing. Replace in case of irregularities. Specific tooling 023638Y Pliers for circlips Check the condition of wear and replace damaged components. Repeat these operations to also release the other side of the engine support from the frame. Undo the fixing screws of the edge.
Always use new gaskets, sealing rings and split pins upon refitting. Tighten the nuts and the screws. Refit the switch in its seat on the steering tube. Her kan du kan du hente den manualer, og andre materialer, omkring Piaggio Ape 50. Left safety lock box 5.
Correctly reposition the cover in its seat above the handlebar and lock it by tightening the fixing screws. Specific tooling 020150Y Support 020151Y Heat gun Remove the bearing from the clutch side crank-. The value of these calibrated parts must correspond to the adjustment data prescribed for the type of carburettor. Remove the cover of the gear. Tighten the cover with the silencer on the secon- dary air system box cover.
Specific tooling 038137Y Rear Hub Extractor Planetary and half-pins In order to optimise the joint of the axle shaft, be careful: - when refitting the two half-pins;. Refit the rear brake pump. Undo the fixing screw and remove the upper cowl. Fitting: Using the appropriate tools necessary, position the crankshaft in its seat. Using a suitable lever release the dashboard from the cab, removing the rubber plugs. Remove the lower seat and the dust gaiter from the steering tube.
Position the gears and the spacer. Separate the brake pedal from the pump. Valve 9, Petrol filter 10. Ladekreds for Ape 50: Ape 50 ladekreds 5 pin regulator på engelsk 829kb. In carrying out this operation, the engine must be fed with a mixture of 2% of appropriate oil at least 0. Insert the handlebar in its appropriate seat on the steering.
Undo the fixing screws of the mixer cover. Undo the top locking nut of the shock absorber to the steering tube. From inside the cab tighten the fixing screws and lock the mudguard. A relatively small number of Apes is still made in Italy. Remove the tie rod fixing screw cotter pin. Remove the engine gear and the key.
Refit on the carburettor the output pipe from the mixer and the vacuum one. Install the washer and the nut. Tighten the fixing screw of the sleeve to the accel- erator pipe. Position the arm under the spring so that the glass closes tightly. Also repeat the operations from the other side of the vehicle. Restore the oil in the gearbox.
The battery produces hydrogen, a gas that can be highly explosive. Remove the spark plug from its seat. Remove the rear shock absorber. In the lower part of the shoe, remove the plate. Refit the front wheel and attach to the drum by tightening the fixing nuts. Rimuovere lo spinotto per mezzo dell'apposito punzone.