Manual kymco xciting 250. KYMCO XCITING 250I OWNER'S MANUAL Pdf Download. 2019-01-31

Manual kymco xciting 250 Rating: 4,2/10 1906 reviews

Kymco Xciting 250 500 AFI (pre 2008) Scooter Owners Manual

manual kymco xciting 250

To protect the catalytic converter in your scooter's exhaust system, avoid extending idling and the use of leaded petrol. The engine will not start. Single brake disc models: Install one stainless steel hub plate 3 between the brake disc and wheel hub. Check the fork assembly by locking the front recommended only when additional protection brake and pumping the fork up and down vigorously. Proper held at a constant speed. Uncover and clean the scooter. Install valve stem assembly L, M or N on wheel.

Next

Kymco Xciting 250

manual kymco xciting 250

All other models: Install wheel spacers previously removed. ÑTerminal caps shall be installed securely. ÑWhen connecting the battery, the positive + terminal must be connected first. Do not attempt to add coolant by removing the radiator cap. After cleaning, rinse the scooter thoroughly with plenty of 1.

Next

Kymco Xciting 250

manual kymco xciting 250

If either pad is worn to the cutout, replace both pads as a set. To adjust: Open the seat see page 34 , Pull the locking lever 2 left on the back and move the backrest back and forth according to the riders preference or physical condition. Refer to Service Manual, Page 5-14 4. Use mild soap and water to clean the windshield and the body panels. With the throttle closed, press the starter button.

Next

Reading : Kymco Xciting 500 250 Afi Service Repair Manual

manual kymco xciting 250

Front brake lever Right handlebar The brake is applied by squeezing the front brake lever gently towards the grip. Check that the oil strainer screen, sealing rubber and drain plug O-ring are in good condition. To lock the box cover , push down on the box cover until it locks. The engine cannot be started if the side stand is down. Put the side stand up and start the engine.

Next

Kymco Xciting 250 Service Manuals

manual kymco xciting 250

Install wheel assembly parts from the appropriate Service Parts table for this fitment and stock brake disc. ÑCheck if any connector terminal is bending, protruding or loose. Holding the front small box lid 2 closed, turn the ignition key counterclockwise. Slide the rubber sleeve 1 back to expose the throttle cable. Install a new air cleaner element.

Next

KYMCO XCITING 250 OWNER'S MANUAL Pdf Download.

manual kymco xciting 250

Rinse the scooter thoroughly with cool water to remove any clean water. Make sure the red low oil pressure indicator goes off. Remove the front seat and disconnect the battery. Charge the battery as required use a quality charger de- signed for use on a maintenance-free type battery. Remove the crankcase breather tube plug 2 from the tube and drain deposits into a suitable container. Drain any excess aerosol rust-inhibiting oil from the fuel tank. Insert bolt through bracket, top of rear shock, and thread into shock tower.

Next

KYMCO XCITING 250 OWNER'S MANUAL Pdf Download.

manual kymco xciting 250

If the lap time continues to run after you press the — button, all 10 memory locations are occupied. Remove the air cleaner element 3 by pull it out. Mount the scooter from the left side keeping at least one foot on the ground to steady the scooter. Discard the air cleaner element. Test the brakes before riding the scooter.

Next

KYMCO XCITING 250I OWNER'S MANUAL Pdf Download.

manual kymco xciting 250

Align holes and replace hardware securing the endhousing back on the winch. This will ensure that the winch drivetrain will not be dislocated during disassembly. The displayed figure cannot be changed. Lock the steering see page 20 to help prevent theft. Under inflated tires can lead to tire failure and loss of vehicle make smooth cornering difficult and control.

Next