. All Rights Reserved Page 52 February 2016. Register a Free 1 month Trial Account. Manual Lycoming Io 360 M1a can be very useful guide, and manual lycoming io 360 m1a play an important role in your products. Refer to the latest revision of Service Instruction No. Remove both spark plugs from each cylinder. All Rights Reserved Appendix C February 2016 Page 51.
Complete a check of the oil level in the oil sump. All Rights Reserved Page viii February 2016. Contact the Publications Clerk at Lycoming Engines at 570- 327-7274. Reference herein to any specific commercial products by trade name, trademark, manufacturer, or otherwise, is not meant to imply or suggest any endorsement by, or affiliation with that manufacturer or supplier. Examine the oil filter and screen. When the engine is received, make sure that the shipping container or box is not damaged.
Figure 6 Starter © 2016 Avco Corporation. Drain the oil, if necessary, to measure the oil quantity. Full feathering check twin engine on the ground is not. Identify and correct the cause. Cylinder 2 is at the front of the engine Figure 9. The crankcase forms the bearings for the camshaft. All Rights Reserved System Description February 2016.
Refer to Appendix A or the latest revision of Service Instruction No. Although Lycoming cannot know all possible hazards or damages, it makes a reasonable effort to supply the best possible guidance and recommended practices for safe operation of its engines. Always refer to the latest revision of any service document for changes or additional information. Nozzle Pressure Appendix C © 2016 Avco Corporation. Prepare an Engine for First-Time Operation 1.
Refer to the fuel flow and consumption curves in Appendix C. Move the propeller control through its complete range as a check for operation and return to the full low pitch position. The fuel line must be intact. Complete the preservative oil removal procedure as follows: A. Refer to Appendix B for ordering information. L114 for a list of Lycoming publications available for purchase.
Not bent or damaged, and does not have any kinks or dents. Prepare the Aircraft Engine Harness Lycoming Engines can supply a wiring diagram to the aircraft manufacturer, which is used to prepare the aircraft engine harness. Overheating Make a safe landing as soon as possible, and identify and correct the cause. Propeller strike, sudden stoppage Make a safe landing. Examine the cylinder bores with a borescope for rust and contamination. Examine the engine, propeller hub area, and cowl for Identify and correct the cause of indication of fuel and engine oil leaks. List of Figures © 2016 Avco Corporation.
Add oil to the engine as required with the specified oil grade Appendix A. All Rights Reserved Appendix B. . Record of Revisions © 2016 Avco Corporation. Service Document List © 2016 Avco Corporation. System Description © 2016 Avco Corporation.
Examine the oil suction screen at the oil sump and the oil filter for blockage or metal deposits. Make sure that each fuel line is intact. During let-down flight operations, it could be necessary to manually lean fuel-injected engines for smooth operation. Long-Term Storage of Engines that Use Automotive Fuel If automotive fuel is used to operate this engine per the latest revision of Service Instruction No. It has tuned induction, and a down exhaust.
Wait at least 30 seconds and repeat the pre-oil start cycle. These engines are usually sent in a box where the engine is attached to a pallet within the box. If a constant speed propeller is to be used: A. All Rights Reserved Page xviii February 2016. Introduction © 2016 Avco Corporation. Apply the preservative oil mixture to each cylinder, one at a time. Table of Contents © 2016 Avco Corporation.