. The 10556 code is not working and it shows it's one of 4 codes. When I turned on the receiver, I still got nothing. In the last 6 months or so, the pass through would not work properly maybe once a month. My apologies if I am not able to make a recommendation for you.
Thank you Hi - and thanks in advance for reading this and any help. Try unplugging everything and plug back in to reset. Perhaps you can try a couple things. I just want to know what a good upgrade to the 591 using the speakers that came with it. Where can I find the list? Can you please help me? Again, not sure if there is a Dennon setting to improve this. For me, It is literally too much work to pull equipment out far enough to reach cables and power cords.
Where can I find the list? It's only affecting the spoken languages too. After changing and making settings. Turn everything off in reverse order. I do have the same problem. In case the voices are getting low only in the center channel it may be a matter to adjust the channel level for this channe only.
Frustrated that I can't figure this out! I did a microprocessor reset, but didnt have time to play with it any more since I had to go to work. I presume that this is likely that the receiver doesn't support those formats, or there are setting on the Dennon - not sure. I tried wiggling all the cables, and nothing. Then turn back on in the forward order. Then if I turned it off, the passthrough would work normally again. Please check other surround modes.
All of the other sound is at volume. I do have the same problem. The 10556 code is not working and it shows it's one of 4 codes. I did try switching through all the surround formats with no joy. . . .
. . . . . . .
. . . . .
. . . . .