Lift up and out on the left and right inside edges 1 and the top and bottom inside edges 2 of the display bezel until the bezel disengages from the display assembly. Perhaps the users of ManualsCat. To create a set of recovery discs: 1. Remove screws securing the hard drive and memory covers. The feet attach to the base enclosure in the locations illustrated below. Removing the Audio Board Reverse the above procedure to install the audio board. After that you can try removing the power jack board without removing the main board.
There should be eight screw covers on the front bezel. Now the laptop starts only if its cold, and runns for a v short time till it freezes and then I have to force shut down. Spread the retaining tabs 1 on each side of the memory module socket to release the memory module. TouchPad Components 1—18 Maintenance and Service Guide. Also, this very well could be failed graphics chip. Remove the memory module compartment cover Section 3.
Also, what about the two pads, Basically where all should I put heatsink compound? Pull the wireless card antenna cable through the opening in the top cover. Now my cooling fan is making awful noises and I can see how to replace it. I have had trouble with turning it on now for a week. Removing the ExpressCard Assembly Reverse the above procedure to install the ExpressCard assembly. I even swapped it out with a different drive. You can then recover back to that point if you want to reverse subsequent changes made to your system. Removing the System Board Screws 5—58 Section.
Remove disc or diskette and reboot. But, it still randomly shuts off. Replace internal keyboard or cable. If the Setup Utility is not already running, begin at step 1. You should ad paypal to the form of donations, I woulda donated something. Does it work fine this way? Adapter lasts 3 months, same issue, buys another adapter, figures the kids are jerking the cord. Reinstalling Preinstalled Programs and Drivers 1.
Amber: All wireless devices are turned off. The more precies your question is, the higher the chances of quickly receiving an answer from another user. Ive used the vacuum cleaner to vacuum out the fan. It gets a too toasty for my liking. Remove both memory modules and look at the sticker. If it is necessary to replace the microphones and cables, release the retention tabs 1 built into the display enclosure that secure the microphones and cables to the display enclosure.
Removing the Display Inverter Maintenance and Service Guide 5—37. Check voltage setting on docking device. The front lights will just flash but nothing will fire up. Removing the Bluetooth Module Reverse the above procedure to install the Bluetooth module. The front edge of the battery disengages from the computer.
Remove the switch cover 3. Maintenance and Service Guide Reseat diskette drive. Could you please help out here? Hope I can get this resolved soon. Reseat internal pointing device connector if applicable. Turn the computer display-side up with the front toward you. Removing the Backlight Cover Maintenance and Service Guide Display Component Recycling D—9.
D—14 Maintenance and Service Guide. Remove two screws securing the wireless card. Disconnect the display cable 2 and the backlight cable 3 from the display inverter. Slide the ExpressCard assembly 2 to the right to disconnect it from the system board. Prepare the computer for disassembly 2. Remove the top cover 2. I also have a problem with the laptop spontaneously losing power and because the battery is undetected it violently turns off without prior warning.